The influence of various factors on the efficiency of screw compressor with liquid injection
Annotation
The article presents the results of a theoretical experiment to determine the point of injection of the liquid working substance in the screw compressor using a mathematical model. Calculations have shown that the most effective positioning the injection point closer to a window injection. To determine the combined effect of liquid injection , was tasked to see how dependent compression work under different operating conditions of the compressor. The amount of liquid while in all cases the same . Injection occurred singly and instantaneously through one point on the rotation angles of the drive shaft relative to the closing of the suction box . The experiment was performed for Boiling 0 , -10, -20, -30 º C and condensing temperatures of 25 and 40 º C. Calculations showed that in all modes of compression produces an increase from 2 to 8 %. Line changes percent increase work clearly shows the reduction of the compression work at the location of injection sites closer to the window injection . Experiments have confirmed that the work of the compressor is increased by injecting the liquid working substance , but this method of cooling of the compressor can be treated with a deficiency of cooling water. The paper also examines the impact of the working properties of substances on the efficiency of the compressor in the injection fluid.
Keywords
Постоянный URL
Articles in current issue
- Criteria of the assessment of efficiency of the mobile dampers established on lamellar surfaces of refrigerators
- Matrix-operator method for calculating the effective characteristics of layered media
- Improving methods of designing cooling systems outdoor sports facilities seasonal operation
- Ranque-Hilsch vortex tube as perspective device of low temperature obtaining
- The method of calculation of the closed type parking ventilation system
- Numerical investigation of the cryodestructive influence on biological tissue