Modeling of working processes of the screw the compressor at productivity regulation
Annotation
The change in the section area of a relief port of a screw compressor, the volumetric capacity of which is regulated by a slide valve, is considered. The analysis of change of the relief port area by the turning angles of the driving rotor shows that if the valve with changed rims is used, then this area in the phase of control is always larger, i. e., the gas dynamic resistance is less. Besides, the mathematical model of the compressor BX-130 (R22) shows that compressor efficiency with the changed slide valve during capacity control is 2 - 8 % higher, than if the standard slide valve is used.
Keywords
Постоянный URL
Articles in current issue
- To the 100th year of the Kholodilnaya Tekhnika magazine!
- The Seventieth birthday of Vitaly Ksenofontovich Bitjukov
- Mathematical modelling and experimental research of the combined cycles of vacuum drying of thermolabile materials
- Cryogenic cycle with superfluid helium
- Bioethanol production from wheat straw
- Aero- and thermodynamic processes in embrasures equipped with thermal curtains
- Improved efficiency of potato storage in the catering establishments
- Therapy by freezing at removal of hepatic metastasises cancer of a thick gut
- Complex estimation of efficiency of central airs Air of premises of residential buildings
- Impact mechanical rocessing on to rheological behavio culinary grease «Byelorussian»
- Research of process of cooling of the packed fish in the environment of a carbon dioxide
- Air resistance of in fin-and-coil heat exchangers
- Exergy analysis of a vaccum freeze drying unit
- The second virial coefficients of ethane and its fluoroderivatives
- Тhe block sorbent-an absorbant of steams for drying refrigerant in a contour of refrigerating machines