Journal
Scientific and technical journal «Priborostroenie»
UDK621.833.15
Issue:2 (61)
Download PDF460 Kbyte
CALCULATION OF ACCURACY PARAMETERS OF EVOLVENT CYLINDRICAL GEAR TRANSMISSIONS
Annotation
The methods for calculating the accuracy of the involute cylindrical gear train (the dead course of the transmission) are considered. Expressions from standards GOST 21098-82 and GOST 1643-81 are analyzed, formulas for calculating the dead run of the gear transmission by the maximum method (in which all parameters take the maximum values) are derived. A formula is given for transferring the magnitude of the dead travel of the transmission from micrometers to angular minutes. Calculation of the dead run of the gear transmission by a probabilistic method (the Monte Carlo method) is performed. An algorithm for calculating the dead path is presented.
Keywords
Постоянный URL
Articles in current issue
- FEATURES OF DESTRUCTION OF MATERIAL SURFACE, STRENGTHENED BY PARTICLES
- METHODS OF COMPENSATION OF THERMO-OPTICAL DISTORTIONS IN ACTIVE ELEMENT OF SOLID-STATE LASER
- VIBROACOUSTIC CONTROL OF WEARING OF SAMPLES OF CYLINDRICAL FRICTION COUPLE
- INVESTIGATION OF TRIBOLOGICAL PROPERTIES OF METAL — NON-METAL FRICTION PAIRS FOR DESIGNING BIOMECHATRONIC SYSTEMS
- INVESTIGATION OF GEAR TOPS WEARING WITH THE USE OF THE EVOLUTION MODEL OF GEAR WHEELS INTERACTION
- KINETICS OF DYNAMICALLY UNBALANCED ROTATOR WITH DRY SLIDING FRICTION IN THE AXLE SUPPORTS
- APPROXIMATE GEAR TRANSMISSION WITH A PIECE-LINEAR CONTACT
- ENERGY-EFFICIENT TRAJECTORY CONTROL OVER MANIPULATORS WITH REDUNDANT NUMBER OF DEGREES OF FREEDOM
- PROBLEMS OF CREATING ACTUATORS BASED ON ELASTIC ELEMENTS
- DESIGNING A TEST BENCH FOR A WAVING WING MECHANISM CONTROL
- DESIGNING COMPOSITE WINDING AND MANAGING THE PROCESS OF ITS FORMATION
- DEVELOPMENT OF SOFTWARE COMPONENT FOR MODULE OF LENGTHY OBJECTS SHOOTING FOR SAWN TIMBER SCANNER
- AN ALGORITHM OF SHARED CONTROL OF INTELLECTUAL WHEELCHAIR MOVEMENT
- DEVELOPMENT OF A REHABILITATION DEVICE FOR THE ELBOW JOINT
- MORPHOLOGICAL ANALYSIS IN THE PROBLEMS OF AUTOMATION OF THE KNEE JOINT IMAGE PROCESSING