The use of hydrophobic tubes of the tube bundle for PSG–2300–2–8–I network water heater exemplified by Petrozavodsk central heating and power plant
Annotation
The paper presents thermal design of heat transfer from the steam to the water network in PSG-2300-2-8-I horizontal network water heaters installed at Petrozavodsk Central Heating and Power Plant, using the hydrophobic tube surface of the tube bundle. A method for obtaining a hydrophobic surface is considered. The average heat transfer coefficient of drip condensation for a horizontal tube bundle, the internal average heat transfer coefficient from the wall to network water, the average logarithmic temperature head in the counter-current flow scheme of heat carriers, and the heat transfer coefficient are calculated. The heating surface area, heating capacity, and steam consumption when using hydrophobic surface of the tube bundle are determined. Giving hydrophobic properties to the outer surface of the tubes in the tube bundle of the network water heater eliminates film condensation and allows going over to drip condensation. The process of heat transfer from steam to network water through the tube wall increases due to the lack of thermal resistance of the liquid boundary layer formed on the outside of the tube during film condensation. The use of hydrophobic tube surfaces provides greater heat transfer efficiency by increasing the heat transfer coefficient. This will reduce steam consumption or increase network water consumption, thereby providing more consumers with the heat energy needed for hot water supply and heating.
Keywords
Постоянный URL
Articles in current issue
- Complex method for automated designing two-sectional centrifugal compressors stage with 3d impeller
- Comparative operation of pharmaceutical refrigerator cabinets
- Technological scheme for solid carbon dioxide production
- The study of y+ influence on the results of nozzle flow numerical simulation in the centrifugal compressor inlet chamber
- Comparative analysis of thermal exchange calculation for refrigerants boiling in channels
- Extraction of crude Mannan oligosaccharides from yeast and their uses
- Justification of the recipe and technology for dried fish-vegetable snacks based on thermomodified Baltic bream tissues
- The use of buttermilk in fermented milk ice cream technology
- Improvement of freezing processes for meat semi-finished products
- Comparative optico-electrochemical research of pro- and antibiotic properties of water plant extracts
- Selection of the temperature regime for freeze-drying spirulina
- Ways to reduce the mass fraction of fat in puff products
- Hopped lemonade production technology
- Interpretation of photonic model for trans-1-chloro-3,3,3-trifluoropropene (HFO-1233zd(E)) thermal conductivity for the liquid branch of the bimodal
- Model of mass transfer in a gas bubble in the mode of developed turbulence