Low-Rigidity Rubber Shock Absorbers for Pipe Mounting
Annotation
Rubber shock-absorbers installed in collars of pipe suspenders are considered. Rigidity characteristics of the shock-absorbers are analyzed. Influence of parameters of pipes on rigidity of the shock-absorber is considered. The main advantage of a standard shock absorber is its versatility and the ability to use it for a large range of pipes. The disadvantage of using it is the restriction on stiffness. The standard shock absorber is compared with a quasi-zero stiffness shock absorber, which allows realization of any stiffness characteristics.
Keywords
Постоянный URL
Articles in current issue
- Algorithms for Evaluating Linear and Volumetric (Weight) Wear Rates of Materials Using a Friction Machine
- Analysis of Reasons for Reduction of Wear Resistance of Polymer Materials in Friction Pairs with Alloy Steel
- Running-in of Materials Under Reciprocating Friction
- Control of Сlamp Load of Interacting Tribocouple
- Study of a Mechatronic Device for Unwinding and Broaching Rolled Materials in Discrete Mode
- Using Nonlinear Spring Accumulators in Balancing Systems and Mechatronic Spring Drives
- Research of a Non-Reversible Step Drive with Energy Recovery
- Development of Energy-Efficient Galloping Robots with Variable-Length Links
- Mass Spectrometric Method for Studying Gas Release During Friction in a Vacuum
- Designing a Spherical Scanner to Study the Spatial Characteristics of Antennas in the Near Zone
- Improving the Design of Supports for a Rotary Viscometer
- Evaluation of Thin Coatings Wear
- Experimental Evaluation of Contact Stresses in Sliding Bearings with Thin-Layer Polyamide Coatings