SYSTEM OF INSULATION STATUS MONITORING FOR ELECTRIC DRIVES IN NETWORKS WITH A DEAD-EARTH NEUTRAL
Annotation
A method for insulation fault detection in variable speed drives operating in TN-networks is proposed. The insulation monitoring system is activated when the electric drive stops. The inverter keys are switched according to a special law, and the leakage current is determined using the current transformer signal, which measures the current in all three phases of the drive simultaneously. The leakage current sensor schematic is considered, and experimental results for various values of insulation resistances are presented. It is shown that the minimum insulation resistance detectable with the method equals approximately to 2 MΩ or lower.
Keywords
Постоянный URL
Articles in current issue
- EFFECT OF ERRORS IN ADJUSTMENT OF QUADRATURE CHANNELS OF A COHERENT SYSTEM ON COMPLEX SIGNAL PARAMETERS ESTIMATION
- NONLINEAR REAL-TIME PROBLEMS IN STOCHASTIC SYSTEM WITH POISSON COMPONENT
- PARAMETERS ESTIMATION OF SINUSOIDAL SIGNAL WITH POWER-LAW FREQUENCY DEPENDENCE
- SYSTEM OF INSULATION STATUS MONITORING FOR ELECTRIC DRIVES IN NETWORKS WITH A DEAD-EARTH NEUTRAL
- MODELLING ROTATIONS OF SOLAR CELLS ON A SPACE VEHICLE. ADEQUACY CHECK
- MODIFICATION OF THE METHOD OF PARAMETRIC IDENTIFICATION OF A SYNCHRONOUS MACHINE WITH PERMANENT MAGNETS
- RELIABILITY OF ADAPTIVE OPTICAL SYSTEM OF TILT CORRECTION
- AUTOMATED DESIGN OF WOODEN CONTAINERS FOR ELECTRONIC EQUIPMENT COMPLEXES
- USING STANDARDS FOR DESIGN ESTIMATES OF THE KINEMATIC ERROR OF GEARS
- DERIVATION OF AN ANALYTICAL SOLUTION TO THE PROBLEM OF ANALYZING A CONCENTRATED VIBRATIONAL EFFECT ON A MEMBRANE-STRIP ELEMENT
- EFFECT OF INTENSIVE PLASTIC DEFORMATION ON THE STRUCTURE AND PROPERTIES OF THE ALUMINUM ALLOY SYSTEM AL-CU-MG