RELIABILITY OF ADAPTIVE OPTICAL SYSTEM OF TILT CORRECTION
Annotation
Laser installation of continuous action is included in an adaptive optical system (AOS) intended for ensuring the required spatial characteristics of the laser beam wave front (WF). The AOS contains two active mirrors: a) the tilt corrector (TC) eliminating the slopes of WF and of the laser beam jitter (corrects about 84 % of WF aberrations), and b) the deformable mirror (DM) eliminating higher orders of the WF aberrations. Control loop of the TC considered in the paper includes tilt corrector, tilt sensor, amplifying unit with a special calculator to generate TC control signals. From the point of view of ensuring dependability in the most difficult conditions, the tilt corrector works. The least dependable in the tilt corrector are piezoelectric actuators subject to cyclic variable electromechanical loads. Technical solutions for control loop of the tilt corrector are analyzed and the reliability requirements are formulated. As a result of the analysis, the critical failures of TC are indicated: reduction in transmitted bandwidth and a loss of compensation ca Надежность адаптивной оптической системы коррекции наклонов 547 ИЗВ. ВУЗОВ. ПРИБОРОСТРОЕНИЕ. 2020. Т. 63, № 6 pabilities. Several issues related to reliability of the AOS elements – drives, TC, control unit, tilt sensor – are considered. A block diagram of the AOS TC is presented and the integrated reliability ratio – the instantaneous operating availability – is evaluated. Reliability of the developed AOC TC elements is confirmed by calculated estimates and presented results of experimental tests of the most critical elements. The developed elements of the control loop TC are shown to meet the imposed requirements.
Keywords
Постоянный URL
Articles in current issue
- EFFECT OF ERRORS IN ADJUSTMENT OF QUADRATURE CHANNELS OF A COHERENT SYSTEM ON COMPLEX SIGNAL PARAMETERS ESTIMATION
- NONLINEAR REAL-TIME PROBLEMS IN STOCHASTIC SYSTEM WITH POISSON COMPONENT
- PARAMETERS ESTIMATION OF SINUSOIDAL SIGNAL WITH POWER-LAW FREQUENCY DEPENDENCE
- SYSTEM OF INSULATION STATUS MONITORING FOR ELECTRIC DRIVES IN NETWORKS WITH A DEAD-EARTH NEUTRAL
- MODELLING ROTATIONS OF SOLAR CELLS ON A SPACE VEHICLE. ADEQUACY CHECK
- MODIFICATION OF THE METHOD OF PARAMETRIC IDENTIFICATION OF A SYNCHRONOUS MACHINE WITH PERMANENT MAGNETS
- RELIABILITY OF ADAPTIVE OPTICAL SYSTEM OF TILT CORRECTION
- AUTOMATED DESIGN OF WOODEN CONTAINERS FOR ELECTRONIC EQUIPMENT COMPLEXES
- USING STANDARDS FOR DESIGN ESTIMATES OF THE KINEMATIC ERROR OF GEARS
- DERIVATION OF AN ANALYTICAL SOLUTION TO THE PROBLEM OF ANALYZING A CONCENTRATED VIBRATIONAL EFFECT ON A MEMBRANE-STRIP ELEMENT
- EFFECT OF INTENSIVE PLASTIC DEFORMATION ON THE STRUCTURE AND PROPERTIES OF THE ALUMINUM ALLOY SYSTEM AL-CU-MG