ANALYTICAL METHOD FOR CALCULATING THE THICKNESS OF PROTECTIVE MASK LAYERS IN THE MANUFACTURING OF A MICROMECHANICAL ACCELEROMETER
Annotation
Methods for determining the thickness of mask layers for plasma chemical etching processes are considered. A method for calculating the thickness of the mask layers during the formation of an instrument layer for the manufacture of sensitive elements of a micromechanical accelerometer is proposed. The results of the evaluation of the calculation method based on the measured values of the mask thickness before and after plasma-chemical etching of the instrument layer on a silicon substrate with sensitive elements are presented. A conclusion is formulated on the effectiveness of using the presented method in the manufacturing technology of micromechanical accelerometers and gyroscopes.
Keywords
Постоянный URL
Articles in current issue
- DIRECT ADAPTIVE COMPENSATION OF MULTI-SINUSOIDAL DISTURBANCES IN LINEAR SYSTEMS WITH FINITE-TIME CONTROLLER TUNING
- METHOD FOR FAULT IDENTIFYING IN NONLINEAR SYSTEMS
- INTELLIGENT INFORMATION AND MEASURING SYSTEM WITH A RECONFIGURABLE STRUCTURE FOR DETERMINING THE THERMAL CONDUCTIVITY OF MATERIALS
- LOCALIZATION OF THE PHASES OF IMPACT-FRICTION INTERACTION OF THE FOOT WITH THE SUPPORTING SURFACE
- REFLECTOR WITH A CYLINDRICAL FACE AND A NON-RIGHT ANGLE BETWEEN THE FLAT ONES FOR THREE-COORDINATE MEASUREMENTS
- REFINEMENT OF THE CALCULATION METHOD FOR AN ACHROMATIC LENS WITH AN OPERATING SPECTRAL RANGE FROM ULTRAVIOLET TO NEAR INFRARED
- FIELD STRENGTH CHARACTERISTICS IN SINGLE-LAYER AND MULTI-LAYER SOLENOIDS: BASIC AND ADAPTIVE. THE ZONE OF UNIFORMITY
- ALGORITHMS FOR AUTOMATED NON-CONTACT CONTROL OF GEOMETRIC CHARACTERISTICS AND ROUGHNESS OF PRODUCTS