Complex method for automated designing two-sectional centrifugal compressors stage with 3d impeller
Annotation
In terms of the current trend for reducing experimental work in the field of compressor engineering, a comprehensive method for automated gas-dynamic designing and profiling a two-stage stage for a centrifugal compressor with an axial-radial impeller has been developed for R & D. The method consists of the synthesis of traditional design approaches using non-viscous quasi-three-dimensional and modern viscous three-dimensional calculations followed by multiparametric and multicriterial optimization. The design process is an alternate process for solving the inverse and direct problem of gas-dynamic calculation. The inverse problem is carried out according to well-established methods of designing at Peter the Great St. Petersburg Polytechnic University. The direct task is the variant profiling of the flow path with the achievement of a rational distribution of the relative velocities of the nonviscous flow on the impeller blades. The loss coefficients in the impeller and vaneless diffuser are estimated on the basis of approximate methods. To clarify the losses and pressure, a viscous three-dimensional calculation is made with an estimated gas-dynamic characteristic. If necessary, the design process is repeated first with new loss factors. At the final stage, in order to achieve perfection of the flow part, multicriterial and multiparameteric optimization is carried out. The article provides an example of successful optimization for a two-stage model stage with an axial radial impeller. The results of the estimated calculation of the loss characteristics in the flow part are demonstrated in comparison with experimental data. The distribution of speeds on three current lines and the calculated characteristic of the theoretical head for the test grid of an axial radial impeller are shown.
Keywords
Постоянный URL
Articles in current issue
- Comparative operation of pharmaceutical refrigerator cabinets
- Technological scheme for solid carbon dioxide production
- The study of y+ influence on the results of nozzle flow numerical simulation in the centrifugal compressor inlet chamber
- Comparative analysis of thermal exchange calculation for refrigerants boiling in channels
- The use of hydrophobic tubes of the tube bundle for PSG–2300–2–8–I network water heater exemplified by Petrozavodsk central heating and power plant
- Extraction of crude Mannan oligosaccharides from yeast and their uses
- Justification of the recipe and technology for dried fish-vegetable snacks based on thermomodified Baltic bream tissues
- The use of buttermilk in fermented milk ice cream technology
- Improvement of freezing processes for meat semi-finished products
- Comparative optico-electrochemical research of pro- and antibiotic properties of water plant extracts
- Selection of the temperature regime for freeze-drying spirulina
- Ways to reduce the mass fraction of fat in puff products
- Hopped lemonade production technology
- Interpretation of photonic model for trans-1-chloro-3,3,3-trifluoropropene (HFO-1233zd(E)) thermal conductivity for the liquid branch of the bimodal
- Model of mass transfer in a gas bubble in the mode of developed turbulence