SILICON PHOTOELECTRONIC MULTIPLIERS AS A BASIS FOR CREATING COMBINED SENSORS
Annotation
The possibility of constructing combined sensors based on silicon photoelectronic multipliers is analyzed. The influence of temperature and supply voltage of silicon photoelectronic multipliers on changes in dark current, sensitivity to optical radiation and critical illumination is investigated. An installation for carrying out the research under consideration is proposed. Experimental samples of Si-photomultiplier tubes (Si-PMTs) with a p+-p-n+ structure produced by JSC Integral (Republic of Belarus), as well as serially produced silicon photomultipliers Ketek PM 3325 and ON Semi FC 30035 are studied. It is shown that the temperature dependence of the dark current for these Si-PMTs has a linear form. The temperature increase is found to decrease the sensitivity of silicon photomultiplier tubes to optical radiation. The value of the critical illumination for Si-PMT is shown to increase with increasing temperature. Based on results of the performed studies, a structure of combined sensor based on silicon photomultiplier tube is proposed, allowing for simultaneous control over the two parameters, temperature and illumination. Main characteristics of this sensor are evaluated.
Keywords
Постоянный URL
Articles in current issue
- METHODOLOGY FOR ASSESSING THE NOISE IMMUNITY OF DATA EXCHANGE RADIO LINES WITH TIME DIVISION OF CHANNELS
- SIMULATION OF SERVERS WITH INTERRUPTS IN LARGE MULTIPROCESSOR SYSTEMS
- COMBINED CONTROL IN DIGITAL TRACKING SYSTEMS IN THE PRESENCE OF DELAY IN THE DIRECT CIRCUIT
- ROBUST CONTROL SYSTEM FOR HEAT EXCHANGER IN HOP EXTRACT PRODUCTION
- METHOD FOR DETERMINING A SPECIAL OPTIMAL CONTROL
- COMBINED OPTICAL METHOD FOR MEASURING THE THICKNESS OF LAYERS OF TRANSPARENT COATINGS AND FILMS
- ANALYSIS OF THE EFFECTIVENESS OF SCHEMATIC DIAGRAMS OF A TUNABLE SOURCE BASED ON AN ACOUSTO-OPTIC FILTER
- SILICON PHOTOELECTRONIC MULTIPLIERS AS A BASIS FOR CREATING COMBINED SENSORS
- INFLUENCE OF STRUCTURAL FEATURES OF CONSTRUCTION POLYMER-COMPOSITE MATERIALS ON THE PHYSICAL AND MECHANICAL PROPERTIES OF PRODUCTS