Planetary temperature calculations under Milankovitch cycles
Annotation
A model for variation with time of the Earth’s planetary temperature while the Earth is moving around the Sun along elliptical trajectory is presented. The model includes an equation for non-stationary heat balance of the Earth; analytical dependence of the solar constant on the distance between the Earth and the Sun; as well as analytical description for variation with time of a distance from the Erath to the Sun depending on the eccentricity of the Earth’s orbit and Earth's rotation period around the Sun. The calculation shows that as the Earth is moving close to aphelion most of the time the insolation of the Erath’s surface decreases when its orbit eccentricity increases. The Earth’s planetary temperature is shown not to change significantly during the year while The Earth is moving from perihelion to aphelion, and the average temperature is shown to decrease by 1.5 K as a maximum if Bond’s albedo of the Earth remains constant. A significant decrease of planetary temperature and an ice age might be possible only if ice-albedo positive feedback takes place when Bond’s albedo increases due to an increase of ice and snow cover of the Earth’s surface. The dynamic of planetary temperature change was calculated assumed that the active layer of the ocean remained constant i.e. 700 m. The selection of active layer depth influences transient thermal processes only and does not influence an average planetary temperature.
Keywords
Постоянный URL
Articles in current issue
- Valorization of residual yoghurt whey by lactic acid production: An optimized process
- New modes of cherry compote sterilization in autoclaves with preheating of fruits in jars with saturated steam and two-stage cooling
- Unit for fine grinding of cottage cheese
- Production of high-quality dry modified collagen products by means of freeze-drying
- Analysis of risk assessment approaches in the transportation of refrigerated containers
- Thermodynamic efficiency of vegetable oil production line with pre extrusion treatment of raw materials
- On the issue of compressible medium leakage in operating unit of single-rotor screw compressor (SSC) with circumferential shape of the tooth
- Thermal calculation of the water outlet device for the polypropylene pipes of cold water supply in winter conditions of the Far North
- The use of the capacitive sensors for the study of condensation processes in the short heat pipes of low-temperature range. Calculation of the sensors
- Features research of experimental and predesign chamber fruits and vegetables store with controlled atmosphere
- The influence of the design parameters for the flow part of short diffusers on their gas-dynamic efficiency
- The influence of absorbent concentration on cooling capacity of heat and mass transfer devices with a mobile nozzle
- Heat and mass transfer in the rooms with forced air supply
- The 23th General Annual Meeting of the International Academy of Refrigeration
- Results of the IAR’s work in 2015-2016 (Report of the IAR President at the 23th General Annual Meeting on 25 May 2016)