![Journal of IAR](/images/mag-vest.jpg)
The influence of the design parameters for the flow part of short diffusers on their gas-dynamic efficiency
![Journal of IAR](/images/mag-vest.jpg)
Annotation
The influence of entrance diameter and length of guides in the short diffuser on pressure losses in its flowing part, and also on uniformity of the profile of its outlet velocities r is analyzed. The analysis is made with the use of the numerical calculation developed on the basis of ANSYS CFX software. Calculations were made for three options of short diffuser design with internal concentric guides along all diffuser length extended into the air duct and shortened. At the same time diameter ratio of inflow and outflow cross section of the diffuser changed from 0.1 to 0.7, and volume rate of airflow from 0.028 to 0.139 m3/s. The analysis proved that the smallest pressure losses occur with the use of extended guides, and the losses decrease with the increase of inflow diffuser diameter. The use of extended guides also provides the most uniform velocity field at the outlet from the diffuser. The results obtained can be useful in designing the flow part for the filters of life support systems.
Keywords
Постоянный URL
Articles in current issue
- Valorization of residual yoghurt whey by lactic acid production: An optimized process
- New modes of cherry compote sterilization in autoclaves with preheating of fruits in jars with saturated steam and two-stage cooling
- Unit for fine grinding of cottage cheese
- Production of high-quality dry modified collagen products by means of freeze-drying
- Analysis of risk assessment approaches in the transportation of refrigerated containers
- Thermodynamic efficiency of vegetable oil production line with pre extrusion treatment of raw materials
- On the issue of compressible medium leakage in operating unit of single-rotor screw compressor (SSC) with circumferential shape of the tooth
- Thermal calculation of the water outlet device for the polypropylene pipes of cold water supply in winter conditions of the Far North
- The use of the capacitive sensors for the study of condensation processes in the short heat pipes of low-temperature range. Calculation of the sensors
- Features research of experimental and predesign chamber fruits and vegetables store with controlled atmosphere
- The influence of absorbent concentration on cooling capacity of heat and mass transfer devices with a mobile nozzle
- Heat and mass transfer in the rooms with forced air supply
- Planetary temperature calculations under Milankovitch cycles
- The 23th General Annual Meeting of the International Academy of Refrigeration
- Results of the IAR’s work in 2015-2016 (Report of the IAR President at the 23th General Annual Meeting on 25 May 2016)